How do I setup my Rockspace Wi-Fi extender?

on

 Rockspace Wifi Extender Setup Manual and WPS Configuration

In this article, we will focus on how you can easily setup your Wifi Rockspace WiFi extender. Ensure that you follow all the steps carefully to complete the process successfully.

Rockspace Extender Setup

Rockspace WiFi Extender Setup Without Ethernet ( WPS) Method

Follow these steps : To Configure Rockspace wifi extender setup with wps method

  • Firstly, you need to plug the Rockspace extender into the power supply. (Ensure that the router is in the same room as well).
  • Now, you need to wait until the PWR LED turns into solid blue. Further, ensure that the antenna is upward and vertical towards the ground.
  • Then, press the WPS button present on your router and wait for at least two minutes and then press the button on the Rockspace Wi-Fi extender.
  • Wait until the Signal LED present on the extender turns into solid blue. This means that the devices are connected to each other.
  • Now, you can move your device back to its place and connect Wi-Fi devices.

Hence, by using the above steps you can setup Rockspace WiFi Extender to the Router without Ethernet Cable.

How to Setup Rockspace Wifi Extender With Ethernet Cable (Without WPS)

You need to follow these steps to configure the Rockspace WiFi Extender setup with ethernet (manual steps) cable.

  • Connect your WI-Fi extender with the computer using an ethernet cable.
  • Now, open any web browser and enter “http://192.168.0.254” or “re.rockspace.local” in the address bar to log into the extender’s web page.
  • Enter your username and password on the login page.
  • After successfully logging in, click on the “extender” option.
  • Now, follow all the on-screen instructions.
  • After doing so, click on the “save” option.
  • When this Rockspace WiFi extender setup process gets completed, unplug your Rockspace extender and place it in a new location.

• Finally, connect your device with the extender

How to log in to the Rockspace Extender?

Carefully follow the below-mentioned steps :

  • Firstly, connect your desktop or mobile with the WiFi extender via WiFi. The name of the network will be “rockspace_EXT”.
  • After connecting, open any web browser and enter “http://192.168.0.254” or “re.rockspace.local” in the URL address box.
  • A login page will appear. Enter your credentials in the boxes and click on “Log in”.
  • Now, you will be logged into the Rockspace extender’s page; you can tweak all the settings or customize them from here easily.

How to Update the Rockspace Wifi Extender's Firmware?

Go through the steps mentioned below :

  • Login to the setup page of Rockspace extender.
  • Click on the “Administration” option.
  • Now select the “Firmware update” option.
  • Then, locate the downloaded file of the latest firmware.
  • Click on “Install”. The process will take up to 2-3 minutes, after which your firmware will be upgraded.
  • The device will also reboot during this process. Therefore, don’t turn off your system in between and download the file only from the official website

Conclusion :

These were some of the easy to go through methods for Rockspace Wifi Extender Setup with and without WPS methods.. Hence, by following these instruction, you can easily configure your extender.

General Question's

My Wi-Fi extender cannot find my Wi-Fi signal but can find someone else's; what to do?
  1. Why is my network slow after using the Wi-Fi extender?
  2. No Internet access after extension; what to do?
  3. Why can't I log in to the web UI of the Wi-Fi extender?
  4. How do i reset my Rockspace Wi-Fi extender?

Comments

Post a Comment